Advertisement
2. Press HR and MIN button to set the timer. Press START/STOP button to start
countdown. " " will blink for every second.
3. To stop the countdown process, press START/STOP button. The " " becomes solid.
4. Press HR & MIN buttons together to clear the setting back to 0:00.
Note: The minimum setting for the timer is 1 minute. When the timer counts down below 1
hour 1:00 the display will change to 59'59" display advising 59 minutes 59 seconds. The
seconds will be shown counting down then. When the countdown reaches 0'00" the timer
starts counting up and it will beep for 60 seconds. The timer and "
START/STOP button to stop beeping. When the count up reaches 23:59:59 (59 seconds
are not displayed) the display will turn to 0:00, the unit beeps and "
seconds.
Count up
1. Press MODE to select timer mode. The upper display will show a small TIMER and 0:00.
2. Press START/STOP button to start count up. The " " will blink for every second.
3. To stop the count up process , press START/STOP button. The " " becomes solid.
4. Press CLEAR button to clear the setting back to 0:00.
HELPFUL HINTS
Do not use the probe wire above 662 °F (350 °C).
Do not allow the probe or probe wire to come into contact with flames. If cooking
with grill cover closed, only use medium or low heat.
If the LCD display LLL or HHH instead of the probe temperature, wait for probe to reach
room temperature. If LLL or HHH is still displayed it is likely the internal probe wire has
shorted out either through moisture or heat damage.
If the probe becomes defective within 90 day warranty period please return defective
probe to address below along with return address and we will send you new probe
no charge.
If the temperature displayed seems to read too high or the temperature seems to increase
too quickly check to make sure the probe tip is not poking through the food to outside.
Reposition the probe tip in the center of the thickest part of food. Avoid touching bone or
heavy fat areas.
Cautions:
Not Intended for Use by Persons ages 12 and under.
Do not use the UNIT in the rain. It is not waterproof.
Do not expose the plug of the stainless steel probe or the plug in hole of the Unit to
water or any liquid. This will result in a bad connection and faulty readings.
Do not expose the Unit to direct heat or surface heat.
Do not use stainless steel probe in microwave oven.
Cleaning
Wash the metal probe tip with hot soapy water and dry thoroughly. Do not immerse the
probe in water while cleaning.
Wipe the UNIT with damp cloth. Do not immerse in water.
LIMITED NINETY DAY WARRANTY
Maverick Industries Inc. warrants the Professional Cooking Thermometer to be free of
defects in parts, materials and workmanship for a period of 90 days, from date of purchase.
Should any repairs or servicing under this warranty be required, contact Maverick
Customer Service by mail or phone for instructions on how to pack and ship the
Professional Cooking Thermometer to Maverick's National Service Center located as
" will blink. Press the
follows:
" will blink for 60
Maverick Customer Service
94 Mayfield Ave.
Edison NJ 08837
www.maverickhousewares.com
Telephone: (732) 417-9666
Hours: Weekdays 8:30 AM- 4:30 PM
Do not send any parts or product to Maverick without calling and obtaining a Return
Authorization Number and instructions.
This warranty is VOID if instructions for use are not followed; for accidental damage; for
commercial use; for damage incurred while in transit; or if the Professional Remote
Cooking Thermometer has been tampered with.
This warranty gives you specific legal rights and you may also have other rights which vary
from state to state.
Advertisement
