3. When the switch is powered on, it executes self-test procedures and
starts up.
CAUTION: The input voltage must be within the required
range; otherwise the switch can be damaged or may
malfunction. Do not open the switch shell as physical
injury may occur.
Switch management
Network administrators can use a simple-to-configure web Graphical User
Interface (GUI) to manage and maintain the switch on their network.
Login web network management
The default Web login process and details are identified below. The default
Web login information includes:
Username:
admin
Password:
admin
IP address of the switch:
192.168.1.1
1. Connect the switch to PC by using an Ethernet cable (not included) to
connect the PC to one of the switch's Ethernet ports.
2. Configure the IP address for the PC and ensure that it can
communicate with the switch. The connection between the switch and
PC can be done by a direct connection or through the network.
For example, change the IP address to 192.168.1.17 to ensure that the PC
and switch are in the same IP subnet.
3. Launch your PC's web browser and type http://192.168.1.1 in the
address bar. Press Enter.
4. On the login page, type admin in the Username field, and type admin in
the Password field. Click Login.
5. To quit and exit, click the log off button on the upper right corner on the
web network management page.
activeARC
web management
®
The web network management page includes: navigation bar, configuration
area, and help area shown below.
3
Contact information
Phone: 1-855.MYARC11 (855.692.7211)
E-mail:
support@activearc.att-mail.com
sales@activearc.att-mail.com
www.att.com/activearc
© 2014 International Communications Corporation, Inc. All Rights Reserved. AT&T and the AT&T
logo are trademarks of AT&T Intellectual Property licensed to lnternational Communications
Corporation, Riverside, California. Printed in U.S.A. Issue 5.1 AT&T 04/28/14. activeARC is a
registered trademark of International Communications Corporation,Inc.
Need help?
Do you have a question about the activeARC and is the answer not in the manual?