Door Reversibility - Zanussi ZFT11112WE User Manual

Location
CAUTION!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and the
wall unit must be at least 100 mm . Ideally,
however, the appliance should not be
positioned below overhanging wall units.
Accurate levelling is ensured by one or more
adjustable feet at the base of the cabinet.
min.
100 mm
15 mm 15 mm

Door reversibility

WARNING!
Before carrying out any operations,
remove the plug from the power
socket.
www.zanussi.com
CAUTION!
To carry out the following
operations, we suggest that this be
made with another person that will
keep a firm hold on the doors of the
appliance during the operations.
1. Tilt back the appliance carefully so that the
compressor cannot touch the floor.
2. Unscrew the left foot.
3. Remove the lower door hinge by
unscrewing the 2 retaining screws.
4. Remove the hinge pin from the bottom of
the door.
5. Slot the hinge pin into the hole in the hinge
plate.
6. Take the door off.
7. Refit the upper hinge pin into the opposite
location.
8. Fit the door in place on the hinge pin.
9. Slot the hinge pin into the hole in the hinge
plate and relocate the hinge assembly to
the opposite location and refit using the
retaining screws.
10. Refit the bottom hinge plate assembly on
the opposite side, taking care that the edge
of the door is parallel with the side of the
cabinet.
11. Remove and install the handle (if foreseen)
on the opposite side.
11