Freestyle FS-80 NG Instruction Manual page 100

W
FreeStyle
ALL
33 Maintenance
2. Remove two (2) Phillips head screws securing the ignition
electrode to the boiler heat exchanger.
3.
Use care when removing and handling igniter.
4.
necessary.
5. Inspect the ignitor ceramic and electrodes.
6. Remove any white oxides accumulated on the ignition elec-
is cracked or damaged, replace.
7. Reinstall ignition electrode, making sure gasket is in good
condition and correctly positioned.
ening the two (2) ignition electrode retainer screws.
DO NOT exceed 20 inch-pounds.
8. Re-attach the ground wire to the electrode assembly.
9.
Figure 130
100
M -
OUNT GAS FIRED WATER BOILER
(continued)
— Use a torque wrench when tight-
—
Boiler Manual
Figure 131
Inspect and clean the burner
Wait until heat exchanger/boiler is cooled down
severe injury.
1. See Figures 131 and 136
cover plate to access burner.
2. Use a 10mm wrench or socket to remove the five (5) nuts
that secure the heat exchanger cover plate to the heat
exchanger.
3. Remove the heat exchanger cover plate and the gasket.
Figure 132
Part number 550-142-850/0115