Table of Contents
Advertisement
Assembling the stand
1.
See the figure above, tighten the screws.
2.
Bend the neck to the desired position for scanning.
3.
Screw mounting: Screw one #10 wood screw into each screw-mount-hole until the base of the stand
is secured.
4.
Tape mounting: ①Peel the paper liner off one side of each piece of tape and place the sticky
surface over each of the three rectangular tape holders. ②Peel the paper liner off the exposed
sides of each piece of tape and press the stand on a flat surface until it is secure.
63
Hide quick links:
Advertisement
Table of Contents
