Scantech MT-6320 User Manual page 40

the previous paired
MT-6320
A Bluetooth device can
be detected but cannot
be connected.
Table 7-3 Cable faults
Fault
Charging fails.
The ActiveSync software
cannot be connected.
Table 7-4 Wi-Fi faults
Fault
An AP cannot
connected.
The MT-6320 does not
support connecting
Bluetooth device without a
password.
Cause
The cable is in poor
contact.
The cable is in poor
contact.
Cause
A message is displayed,
showing that the AP is
unavailable.
be
A message is displayed,
showing that the AP is
being connected.
a
Set a password for the Bluetooth device.
Solution
Replace the cable.
Replace the cable.
Solution
Start the WLAN device.
The DHCP function is not enabled on the
AP/router and the IP address cannot be set.
In this case, set the IP address manually.
The password of the WLAN device is
incorrect.
Too many devices access the AP at the same
time. In this case, restart the AP.
When WLAN is in Adhoc mode, modify the
advanced setting of WLAN to Access Point
only.
The password mode of the AP is incorrect. In
this case,
authentication mode.
- 37 -
MT-6320 User Manual
change the password