Cleaning And Maintenance - Sunbeam SU1400-CN Instruction Leaflet

Ultrasonic
Table of Contents

Advertisement

C L E A N I N G / M A I N T E N A N C E
Figure 3: Control Panel
ON /
Low Mist
Standby
Control Knob
Figure 4
A
B
C
D
E
F
G
H
A. Mist nozzle
B. Tank Handle
C. Decorative /
Removable Tank Cover
D. Water Tank
E. Water Tank Base Cover
F. Humidifier Base
G. Airflow Outlet
Indicator Light:
Red: Low Water
Green: Normal
High Max Mist
M
L
K
J
I
H. Control Knob
I. Power/Low Water
Indicator Light
J. Transducer
K. Water Basin
L. Drain Outlet
M. Water Level Sensor

CLEANING AND MAINTENANCE

INSTRUCTIONS
Humidifiers provide comfort by adding moisture to dry,
heated indoor air. To benefit most from the humidifier
and avoid product misuse, follow all instructions carefully.
Please note that this is an electrical appliance and
requires attention when in use.
In addition, if you do not follow the recommended care
and maintenance guidelines, micro-organisms may be
able to grow in the water within the water tank. You must
routinely follow the cleaning procedures that follow in
order to ensure proper, efficient operation of your
humidifier. Proper maintenance and cleaning is essential
to the continued performance of your unit and the
avoidance of algae or bacteria build-up.
Daily Maintenance:
1. Be sure the unit is OFF and is disconnected from the
electrical outlet.
2. Remove the tank from the base of the unit, drain
and rinse the base and tank thoroughly to remove
any sediment or dirt. Wipe clean, and dry with a
clean cloth or paper towel.
3. Refill tank with cool tap water as instructed earlier in
the Filling Instructions. Do not overfill.
4. Follow Operating Instructions to turn on the humidifier.
Weekly Maintenance:
To Remove Scale:
1. Repeat previous steps in Daily Maintenance.
2. Clean the base by partially filling the base with one
8-oz cup of undiluted white vinegar. Leave this
solution in the base for 20 minutes, while cleaning all
the interior surfaces with a soft brush (brush not
included). Gently scrub the area around the
transducer with a soft brush. Remove base scale by
wiping the base with a cloth dampened with undiluted
white vinegar.
3. Rinse with clean warm water to remove the cleaning
solution before disinfecting the tank.

Advertisement

Table of Contents
loading

Table of Contents