Chevrolet 1986 Corvair Owner's Manual page 8

STANDARD NO. III
Rearview Mirrors
Purpose and Scope. This standard specifies requirements for
rearview mirrors to provide the driver with a clear and rea-
sonably unobstmcted view to the rear.
STANDARD NO. 203
Impact Protection for the Driver From the Steering Control
System
Purpose and Scope. This standard specifies requirements for
steering control systems that will minimize chest, neck, and
facial injuries to the driver as a result of impact.
STANDARD NO. 204
Steering Control Rearward Displacement
Purpose and Scope. This standard specifies requirements
limiting the rearward displacement of the steering control
into the passenger compartment to reduce the likelihood of
chest, neck, or head injury.
STANDARD NO. 205
Glazing Materials
Purpose and Scope. This standard specifies requirements
for glazing materials to reduce lacerations to the face, scalp,
and neck, and to minimize the possibility of occupants being
thrown through the vehicle windows in collisions.
STANDARD NO. 206
Door Latches and Door Hinge Systems
Purpose and Scope. This standard specifies load require-
ments for door latches and door hinge systems to minimize
the probability of occupants being thrown from the vehicle
in a collision.
STANDARD NO. 207
Anchorage of Seats
Purpose and Scope. This standard establishes requirements
for seats, their attachment assemblies, and their installation
to minimize the possibility of failure by forces acting on the
seat as a result of vehicle impact.
5
STANDARD NO. 208
Seat Belt Installations
Purpose and Scope. This standard establishes requirements
for seat belt installations.
STANDARD NO. 209
0
Seat Belt Assemblies
Purpose and Scope. This standard specifies requirements
for seat belt assemblies.
STANDARD NO. 210
Seat Belt Assembly Anchorages
Purpose and Scope. This standard specifies the requirements
for seat belt assembly anchorages to ensure proper location
for effective occupant restraint and reduce the likelihood
of failure in collisions.
STANDARD NO. 211
Wheel Nuts, Wheel Discs, and Hub Caps
Purpose and Scope. This standard precludes the use of wheel
nuts, wheel discs, and hub caps that constitute a hazard to
pedestrians and cyclists.
STANDARD NO. 301
Fuel Tanks, Fuel Tank Filler Pipes, and Fuel Tank Con-
nections
Purpose and Scope. This standard specifies requirements
for the integrity and security of fuel tanks, fuel tank filler
pipes, and fuel tank connections to minimize fire hazard as
a result of collision.
PUBLIC LAW 87·637 (1962)
*
An Act to provide that hydraulic brake fluid sold or
shipped in commerce for use in motor vehicles shall meet cer-
tain specifications prescribed by the Secretary of Commerce.
The requirements of this law were issued as standards when
the National Traffic and Motor Vehicle Safety Act of 1966
was enacted.
"The Seat (Lap) Belt and Brake fluid standards are applicable
to all 1968 models of affected vehicles.