Adjusting The Handle Height - Toro 51488 Operator's Manual

4
Installing the Auxiliary Handle
Parts needed for this procedure:
1 Auxiliary handle
1 Latch
1 Brace
Procedure
1. Position the auxiliary handle on the upper shaft of the
trimmer with the smooth surface facing the operator
5).
1. Auxiliary handle
2. Latch
2. Slide the brace into the auxiliary handle so that the brace
rests in the groove along the shaft
3. Slide the latch from the left through the handle and brace as
shown in Figure 5, and tighten the latch screw with a Phillips
screwdriver.
Figure 5
3. Brace
4. Upper shaft
(Figure 5).
5

Adjusting the Handle Height

No Parts Required
Procedure
To adjust handle height, flip the auxiliary handle latch, slide it up
or down to the desired height, then secure it in place by closing
the latch (Figure
(Figure
1. Auxiliary handle
7
6).
Figure 6
2. Auxiliary handle latch