Installing The Guard - Toro 51488 Operator's Manual

2

Installing the Guard

Parts needed for this procedure:
1 Guard
2 Phillips screw
2 Washer
2 Lock washer
Procedure
1. Remove the 2 Phillips screws and washers taped to the
guard (Figure 3).
2. Slide the guard onto the trimmer base as shown in
1. Phillips screw
2. Washer
3. Secure the guard using 2 Phillips screws.
Figure 3
3. Guard
4. Lock washer
3
Installing the Edge Guard
Parts needed for this procedure:
1 Edge guard
Procedure
Insert the ends of the wire edge guard into the holes in the trimmer
housing as shown in
Figure 3.
1. Wire guard
6
(Figure 4).
Figure 4