Table of Contents
Advertisement
34
DX-32D310NA15
Using the remote control
Installing remote control batteries
1 While pressing the release latch on the back of the
remote control, lift the battery compartment cover
off the remote control.
2 Insert two AAA batteries into the battery
compartment. Make sure that you match the + and –
symbols on the batteries with the + and – symbols in
the battery compartment.
1
Replace the battery compartment cover.
Cautions
• Batteries should not be exposed to
• Battery chemicals can cause a rash. If
• Make sure that batteries are disposed
Notes
• Do not mix batteries of different types.
• Do not mix old and new batteries.
• Remove batteries when the charge is
• If the remote control is not going to be
Aiming the remote control
• Point the remote control towards the remote sensor
on the front of your TV. For the location of the remote
control sensor, see "Front" on page 8.
excessive heat, such as sunshine, heat
registers, or fire.
the batteries leak, clean the battery
compartment with a cloth. If
chemicals touch your skin, wash
immediately.
of correctly. Do not burn or incinerate.
depleted.
used for an extended period of time,
remove the batteries.
Turning on your TV for the first
time
The first time you turn on your TV, the Setup Wizard
opens. The Setup Wizard guides you through setting up
basic settings including the menu language, time
setting, picture mode, and the TV signal source.
1 Make sure that you have:
• Installed the remote control batteries. (See page
for details.)
• Connected an antenna, cable TV, or satellite TV.
(See page
• Connected the power cord. (See page
details.)
2 Press
Menu Language screen opens.
3 Press
then press ENTER. The Choose Your Time Setting
screen opens.
4 Press
select Manual (to set the date and time manually) or
Auto (to set the date and time automatically from a
TV signal source based on the time zone you select).
www.dynexproducts.com
Dynex 32" LED TV
13
through
18
for details.)
(power) to turn on your TV. The Choose Your
or
to highlight the language you want,
or
to highlight Mode, then press
Note
If you select Auto, the displayed time will
be incorrect until your TV gets the correct
time from a TV signal source.
34
33
for
or
to
Advertisement
Table of Contents
