Water Fill - Aircare 5D6700 Use And Care Manual

thermostat and hot air registers. Position humidifier next to an inside wall on a level
place at least 4 inches away from the wall or curtains.
ASSEMBLY
1) Unpack humidifier from carton.
2) Remove all packaging material, wicks, etc. from cabinet. REMOVE THE
PLASTIC WRAP FROM AROUND EACH WICK.
3) Place the wicks in position by sliding them into the mounting ribs molded into the
bottom of the cabinet.
4) Insert the plastic platform with the circular cutout (transitional molding) on top of
the mounted wicks. Note that the transitional molding is notched and marked
"FRONT" to indicate proper placement.
Transitional
Molding
Cabinet/
Water reservoir
Chassis (Top portion of unit)
Cabinet
Transitional Molding
Humidifier Wicks (2 Required)
Air Purifying Filter (Optional)

WATER FILL

CAUTION: Before filling, ensure unit is turned OFF and unplugged.
1)
Before replacing the chassis, fill the cabinet with unsoftened water. DO NOT
POUR WATER OVER THE ELECTRICAL CHASSIS. Fill the cabinet only
through the opening between the wick and the cabinet sidewall. Note the MAX.
notation on the side wall of the cabinet. DO NOT OVERFILL. Cabinet capacity is
3.0 gallons.
NOTE: We recommend using AIRCARE
when you refill the water reservoir to eliminate bacterial growth. Add bacteriostat
according to the instructions on the bottle.
Under no circumstances should you use Water Treatment products intended for
Rotobelt or Ultrasonic humidifiers.
Air Intake Section of Grille
Digital Control Panel
Replacement Parts Available For Purchase
Description
Air Exit
Section
of Grille
1040 Wicks
(2 required)
Optional 1050
Air Purifiing Filter
Part Number
1B72700
1B71784
1B71786
1040
1050
® ®
or Essick Air Bacteriostat Treatment
4
Chassis
BACK VIEW