Toro Groundsmaster 4500-D Operator's Manual page 36

•
Steering cylinder ball joints (2)
1. Top fitting on king pin
•
Tie rod ball joints (2)
•
King pin bushings (2)
the king pin should only be lubricated annually
(2 pumps).
•
Lift arm bushings (1 per deck)
•
Lift cylinder bushings (2 per deck)
(Figure 25)
Figure 25
(Figure 25)
(Figure 25). The top fitting on
(Figure 26)
Figure 26
(Figure 26)
•
Cutting unit spindle shaft bearings (2 per cutting unit)
(Figure 27)
Note: Either fitting can be used, which ever is more
accessible. Pump grease into the fitting until a small
amount appears at bottom of the spindle housing (under
the deck).
•
Cutting unit carrier arm bushings (1 per cutting unit)
(Figure 27)
•
Rear roller bearings (2 per cutting unit)
Important: Make sure the grease groove in each
roller mount aligns with the grease hole in each end
of the roller shaft. To help align the groove and hole,
there is also an alignment mark on one end of the
roller shaft.
36
Figure 27
(Figure 28
Figure 28
)