Connecting To The Vdsl Line Interface - GDI XC300 Owner's Manual

CONNECTING TO THE VDSL LINE INTERFACE

The XC300 supports communication between two Ethernet LAN sites over a distance of
up to 4,000 ft (1,219 m) over 24 AWG (0.5 mm) twisted-pair wire. Actual distance and
link performance may vary depending on the environment and type or gauge of wire
used.
Follow the steps below to connect the XC300 VDSL Interfaces.
The XC300 is a pair of units. One of the units must be an XC300NT, and the other unit
must be an XC300LT. It does not matter which end is the XC300NT and which is the
XC300LT. The XC300LT always initiates the link. As long as the XC300NT is powered
on, the XC300LT can establish a link by being powered ON or by a power reset.
To function properly, the units must be connected together using twisted-pair,
unconditioned, metal wire, between 19 (0.9mm) and 26 AWG (0.4mm). Leased circuits
that run through signal equalization equipment are not acceptable. The interface is
bipolar making the TIP and RING connection non-critical.
XC300(RJ11) VDSL Line Interface
8