Because the XC300 requires no configuration, it can be installed and made
operational quickly. Installation takes place as follows
1. Connecting the VDSL line interface between the units (refer to section titled,
"Connecting the VDSL Line Interface" on page 8) See Figure 4 for the rear panel
connector arrangements.
2. Connecting the Ethernet interface (refer to section titled, "Connecting the LAN
(10/100Base-T) Ethernet Interface" on page 9).
3. Connecting the POTS to a telephone or telephone line (refer to the section titled
"Connecting the POTS/ISDN line" on page 11)
4. Connecting the power plug (refer to section titled, "Connecting Power" on page 11).
INSTALLATION
XC300
7