Connecting The Telephone (Pots/Isdn) Line; Connecting Power - GDI XC300 Owner's Manual

CONNECTING THE TELEPHONE (POTS/ISDN) LINE

The RJ 11 port labeled "PHONE" is the TELEPHONE or POTS/ISDN interface. A
telephone or an ISDN device may be connected to this port and carried over the VDSL
line. The XC300 does not need to be powered ON for the POTS interface to work. The
RJ 11 connector in the XC300 PHONE interface is wired as shown in Figure 10.
Figure 10.
XC300 PHONE (RJ 11, POTS/ISDN) interface

CONNECTING POWER

An external AC cube style power supply is available. Power to the XC300 is connected
using the barrel jack on the rear panel. No configuration is necessary for the power
supply. DC power supplied must meet the following requirements; DC power must be
regulated +5VDC ±5%, 1.0A minimum. Center pin is +5V. The barrel type plug has a
2.5/5.5/10mm I.D./O.D./Shaft Length dimensions. The XC300 does not have a power
switch, it powers up as soon as it is plugged in.
11