Table of Contents
Advertisement
Interior Lamps
Instrument Panel Brightness
The instrument panel brightness control
knob (
) is located next to the exterior
lamps control switch on the left side of
the instrument panel.
Press and release to extend the knob;
then turn it to adjust instrument panel
brightness.
Turn the knob clockwise all the way to
turn on the interior lamps.
Dome Lamps
Entry Lighting: When a door is opened,
the dome lamps will come on. When the
door is closed, the lamps will remain on
for 15 seconds or until the vehicle is
started.
Exit Lighting: When the key is removed
from the ignition, the dome lamps will
come on for 40 seconds.
Dome Lamp Override: To turn off the
automatic operation of the dome lamps,
press this button (
exterior lamp control switch. Press
it again to return the lamps to automatic
operation.
) located below the
Note: The Dome Lamp Override button
will not override the entry lighting fea-
ture if the Remote Keyless Entry trans-
mitter is used to unlock the vehicle.
Reading Lamps: Press the button next
to each lamp to turn it on and off.
See Section 3 of your Owner Manual.
Cruise Control
The cruise control functions are located
on the turn signal/multifunction lever.
(Off): This position turns off the
system.
(On): This position turns on the
system.
+
(Resume/Accelerate): Push the lever
to this position to resume the set speed
or to increase the set speed.
(Set): Press this button at the end
of the turn signal/multifunction lever to set
the speed or to decrease the set speed.
When the cruise control is active, the
CRUISE light in the instrument cluster
will illuminate.
11
Advertisement
Table of Contents
