Body/Chest Mounting - Fisher Coinstrike Operating Manual

BODY/CHEST MOUNT
It is especially important that the cable connector be installed
tightly to prevent false signals during body-mount use. Tight, but
never tightened with anything but your hands.
1. Disconnect the cable from the control housing
and unwind all but the last 12 inches or so from the
stem. Secure the lower end of the cable with a
Velcro strap at least 12 inches up from the coil.
2. Remove the control housing from the pistol grip
by holding the grip with one hand and sliding the
housing toward you with the other hand.
3. Attach the belt clip to the control housing by
slipping it over the brass posts on the bottom of the
control housing and pulling it toward the control
panel to lock it in place.
4. Reconnect the cable to the control housing.
5. The control housing can then be mounted on your
belt or on the optional Fisher Chest Harness.
5