High valley stoves - installation, operation, & safety handbook (16 pages)
Summary of Contents for High Valley 1300
Page 1
The Owner’s Manual contains important safety, opera ng, and maintenance informa on. Please read and understand the en re Owner’s Manual before installing or opera ng this wood heater. If you have ques ons please contact your High Valley Dealer for assistance. SAVE THIS OWNER’S MANUAL FOR FUTURE REFERENCE...
Page 2
MODEL 1300 Safety Tested by: Emissions & Effi ciency Tested by: OMNI- DIRIGO Test Laboratories, Inc | Portland, Oregon Laboratories, Inc | Clackamas, Oregon Report 512-S-01-2 | Tested 12/2012 to UL 1482-2011 & ULC S627-00 Report 014-S-001-1 | Tested to July 1990 Particulate Emission Standards U.S.
Page 3
This manual describes the installa on, opera on, and maintenance of High Valley Stoves Model 1300 non-cataly c wood heater. This heater is cer fi ed to comply with the U.S. Environmental Protec on Agency’s crib wood emission limits for wood heaters sold a er May 15, 2015.
Page 4
Thank you for choosing a wood heater from High Valley Stove. Safe and effi cient opera on of your wood heater depends greatly on proper installa on as outlined in this owner’s manual. If this wood heater is not properly installed, a house fi...
Page 5
Your new High Valley Model 1300 has been designed to give you years of clean, effi cient service. Take me to consider carefully where your new wood heater will be installed in your home. If you are planning to use an exis ng chimney and/or hearth, many of the decisions have been made for you.
Page 6
fl ue gases are diluted by the extra air in the larger fl ue and cool faster Dra is decreased and, if cooled too much, creosote may be deposited in the fl ue. The Model 1300 has a 6" fl ue collar and 6" factory-built HT chimney is readily available.
Page 7
Your High Valley Model 1300 must be connected to either a factory-built Type HT chimney or to a masonry chimney with a fl ue liner of a construc on that meets all current code requirements. If the wood heater is to be connected to an exis ng chimney , have the chimney inspected prior to installing the wood heater by an NFI cer fi...
Page 8
• Special care must be exercised to ensure that all chimney clearances to combus bles meet current standards. • Exis ng chimneys should be inspected to ensure that clearances to combus bles are in compliance. • Factory-built chimney clearances are defi ned in the manufacturer's installa on instruc ons. •...
Page 9
1300 S Model 1300 Over All Width: 22 ½” Flue Size: 6” Model 1300 Over All Depth: 23 ½” Firebox Volume: 1.34 cu. . Model 1300 Height with Pedestal: 30” Firebox Dimensions: 16" wide x 11" deep Weight: 314 lbs Maximum Log Length: 314 lbs.
Page 10
Dealer has un-boxed and assembled your stove prior to delivery. Your dealer has the equipment and the experi- ence to handle heavy stoves. If you have taken delivery of your Model 1300 stove s ll in the box proceed as follows: •...
Page 11
• With the fl oor protec on in place, carefully move the Model 1300 into posi on. • Use extreme cau on when li ing the Model 1300. It is VERY HEAVY. We recommend the use of li ing straps (fur- niture moving straps) by at least two strong individuals.
Page 12
fl ue collar using three (3) #10 sheet metal screws (see Page 11). The Model 1300 was not designed or tested for installa on into a fi replace. The top vent only confi gura on of the Model 1300 makes ven ng into most masonry fi replaces imprac cal.
Page 13
Over-fi ring can cause damage to the wood heater and may cause a fi re. burns or scalding. 1300 F : Powered by the standard convec- on blower to deliver heated air to the room.
Page 14
CAUTION: Before ligh ng your wood heater please During the fi rst stage of combus on read and/or re-read the safety informa on on pages 2, 4, keep the Air Damper fully, or nearly fully, open to help 13, and elsewhere throughout this manual. Ensure that drive off...
Page 15
Contact your High Valley dealer or local chimney sweep if you are Heavy deposits may be removable with a damp cloth or uncertain how to inspect the system for any build-up.
Page 16
Do not subs tute materials when purchasing homes to improve stove performance. An outside air kit parts or other materials. Contact your High Valley dealer P/N AIRKIT) is available through your High Valley dealer. for assistance.
Page 17
Combus on Triangle together in your wood heater and you will have started a fi re. The chemical and physical The Model 1300 is designed and approved for use processes taking place in that fi re are complex, and scien- with solid natural wood.
Page 18
APPENDICES B & C B ̴ H Natural C ̴ F UL Stan- cord wood does not come with a specifi ca on sheet like dard 1618; the Standard for Wall Protectors, Floor Protec- the building materials described in Appendix C. Manu- tors, and Hearth Extensions, was adopted as a standard factured products can be made to strict, repeatable tol- in 2011.
Opera ng Instruc ons, or due to negligence or carelessness; Damage caused by misuse, accident, neglect, or willful abuse of the product; damage caused by the use of any type of coal in any High Valley stove. (The use of seasoned wood is required.);...
Page 20
OWNER' RECORD 1300 High Valley Model: Serial Number: High Valley Dealer: Date of Purchase: Installed by: Installa on Date: Inspected by: Date of Inspec on: NOTES: 185 Highway 201 │ Abbeville, SC 29620 www.highvalleystoves.com HL1350 ̴ Rev. 05/2015...
Need help?
Do you have a question about the 1300 and is the answer not in the manual?
Questions and answers