Page 1
Installation, Operation, & Safety Handbook 153 Hwy. 201 High Valley Stoves by Stoll Abbeville, SC 29639 www.highvalleystoves.com 800.421.0771 Model 1600 Safety Notice: If this wood stove is not properly installed, a house fire may result. For your safety, please follow the installation directions.
Page 2
NOTICE Gold plated surface must be cleaned with glass cleaner and a soft rag before firing the first time, or fingerprints will remain. High Valley Stoves by Stoll 153 Hwy. 201 Abbeville, SC 29620 P: 800.421.0771 W: www.highvalleystoves.com E: sales@highvalleystoves.com...
For additional information on using your heater (wood stove) safely, send for Using Coal and Wood Stoves Safely, NFPA No. 81974, from the National Protective Association, 470 Atlantic Avenue, Boston, MA 02210. High Valley Stoves are tested by Arnold Green Testing Laboratories, 2 Millbury Street, Auburn, MA 01501. Safety Precautions 1.
Page 5
13. Use only an insulated, all fuel chimney to vent the hot gases out of the house. It will reduce the amount of creosote buildup and improve the draft needed to vent hot gases from the stove. 14. Use a 6” diameter insulated thimble, or a 6” diameter insulated all-fuel chimney section when passing through a combustible wall or ceiling.
Section 2: Installations Stove Installation Figure 1. Leg Installation 1. Start 3/8” bolts and washer (provided) into taped holes on bottom of unit. 2. Using 8” blocks, shim front of stove and attach front legs. Tighten bolts securely. 3. Shim rear of unit and attach two rear legs, being sure to tighten bolts securely. 4.
Place the 6” X 2” plate (provided with the outside kit) over this opening and attach. Firebrick & Fireblanket Installation The 1600 is shipped with both the firebrick and fireblanket already installed. In the event the firebrick or fireblanket need to be reinstalled you should follow the diagram below.
Section 2: Installations (cont.) Optional Blower Installation 1. Remove blower from box. 2. Place blower on rear of unit in rectangle opening. Align slots on either side of unit with holes on rear of unit. 3. Bolt blower onto unit with 2 3/8” bolts provided. 4.
4. This stove is designed to burn dry, seasoned hardwood. 5. Avoid coming in contact with the firebrick or air tubes when loading wood into the unit. 6. Once the fire is burning, you can control the fire by using the control on the right hand side of the unit.
Page 10
This limited warranty covers all stoves manufactured by Stoll Fireplace Inc. and carrying the High Valley Stoves brand. *The warranty will be void if coal is burned in any High Valley wood burning stove. General Warranty Provisions High Valley Stoves, warrants the model 2500 and 1500 against defects in material and workmanship...
Page 11
City: State: ZIP: Phone: Email: Stove Was Purchased At: Selling Price Less Tax: Date Purchased: Date Installed: Model Purchased: 1600 Wood Stove Serial Number: (found on rear of unit) Remove page from book then fold in half and tape. 800.421.0771...
Page 12
From: Place Stamp Here High Valley Stoves by Stoll 153 Hwy. 201 Abbeville, SC 29620...
Need help?
Do you have a question about the 1600 and is the answer not in the manual?
Questions and answers