Nokia N97 mini User Manual page 53

Password — A password may be needed to make a data
connection, and is usually provided by your service provider.
Authentication — To always send your password
encrypted, select Secure. To send your password encrypted
when possible, select Normal.
Homepage — Depending on the access point you are setting
up, enter the web address or the address of the multimedia
message centre.
Use access point — Set the device to connect to the
destination using this access point after confirmation or
automatically.
Modify advanced packet data access point settings
Select Options Advanced
>
Select from the following:
Network type — Select the internet protocol type to transfer
data to and from your device. The other settings depend on
the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address of
your device.
DNS addresses — Enter the IP addresses of the primary and
secondary DNS servers, if required by your service provider.
To obtain these addresses, contact your internet service
provider.
Proxy server address — Enter the address of the proxy
server.
Proxy port number — Enter the port number of the proxy
server.
© 2010 Nokia. All rights reserved.
settings.
WLAN internet access points
Select Menu Settings
>
Destinations Access
>
To edit a wireless LAN (WLAN) access point, open one of the
access point groups, and select an access point marked with
.
Follow the instructions from your WLAN service provider.
Select from the following:
WLAN network name — Select
for networks. If you select an existing network, WLAN
network mode and WLAN security mode are determined by
the settings of its access point device.
Network status — Define whether the network name is
displayed.
WLAN network mode — Select
network and to allow devices to send and receive data
directly; a WLAN access point device is not needed. In an ad
hoc network, all devices must use the same WLAN network
name.
WLAN security mode — Select the encryption used: WEP,
802.1x, or WPA/WPA2 (802.1x and WPA/WPA2 are not
available for ad hoc networks). If you select
no encryption is used. The WEP, 802.1x and WPA functions
can be used only if the network supports them.
Homepage — Enter the web address of the starting page.
Use access point — Set the device to create a connection
using this access point automatically or after confirmation.
and Connectivity
>
point, and follow the instructions.
Enter manually
Ad-hoc to create an ad hoc
Open
or Search
network,
53