Jenn-Air JB36NXFXLW Installation Manual page 25

Door Swing Adjustment
It may be necessary to adjust the swing of the door(s). Make sure
the refrigerator door(s) can open freely. If the door(s) opens too
wide, install the door stop pin (provided with refrigerator).
1. Hold the door open to a position that is less than 90°.
2. Insert the door stop pin into the top hinge in the hole shown.
3. Using a ⁵⁄₃₂" hex key, tighten the door stop pin.
A. Door stop pin hole
Complete Panel Installation
1. Use the installation block to measure the gaps between the
panels and adjacent cabinets.
Custom wood overlay panels may be made with a ³⁄₈"
(0.95 cm) or ¹⁄₈" (0.32 cm) gap between the panel and
cabinets and a ¹⁄₈" (0.32 cm) gap between the freezer and
refrigerator door(s) and the door(s) and top grille.
All purchased panel kits require a ³⁄₈" (0.95 cm) gap
between the panel and the cabinets and a ¹⁄₈" (0.32 cm)
gap between the freezer and refrigerator door(s), and the
door(s) and top grille.
A
B
A. Adjacent cabinet
B. Installation block
C. Panel on door
2. Adjust the panel to achieve the required spacing, or to align.
IMPORTANT: If adjustments are needed, adjust the panel not
the door. Adjust left to right in the mounting bracket before
using the pins to adjust the panel up and down or at an angle.
Slide the panel from side to side in the keyhole slot.
Use a ⁵⁄₃₂" hex key to raise or lower the adjustment pins
which allows the door panel to swivel.
A
3. Predrill pilot holes, using an ³⁄₃₂" drill bit, into the door panel(s)
through the open holes in both the bottom and top hinges.
4. Using the slotted hex-head screws (provided with refrigerator),
attach the top and bottom hinges to the door panels. Fully
tighten all door panel screws.
NOTE: For 36" models, there is an additional bracket at the
top to fasten the panel to the door. Insert the screws through
the bracket into the door panel.
A. Top hinge
B. Panel top bracket
C. Holes for screws
5. Using slotted hex-head screws (provided with refrigerator) for
each side, attach the door panels to the hinge-side door trims.
C
6. Using Phillips-head flat screws (provided with refrigerator),
install the handle side door trim.
7. Completely tighten the screws attaching the mounting
brackets, located at the bottom of the doors, to the panels.
8. Reinstall the top door trim and hinge cover.
9. Snap the door adjustment pin cover (provided with
refrigerator) into place.
C
A. Door panel
B. Panel top bracket
C. Adjustment pins
A B
C D
D. Door adjustment pins
E. Holes for screws
(36" models only)
A
B
E
25