Jenn-Air JB36NXFXLW Installation Manual page 23

Drawer Panel
IMPORTANT: This step is complete on Jenn-Air Stainless Steel
Panel Kits.
1. Using the Phillips head flat screws (provided with refrigerator),
fasten a drawer panel bracket to each side of the drawer
panel, as shown.
A
A. Drawer panel
B. Drawer panel mounting bracket
Top Grille Panel
IMPORTANT: This step is complete on Jenn-Air Stainless Steel
Panel Kits.
1. Using the slotted hex-head screws (provided with refrigerator),
attach a mounting bracket to each side of the top grille panel.
IMPORTANT: See the "Parts Provided" section to select the
brackets designated for your installation.
Use the Fully Integrated Grille brackets for a fully
integrated grille installation with a full height grille.
Use the standard grille brackets for a Standard Integrated
Grille installation with a flush grille, as shown.
A. Top grille brackets
B. White, grille trim piece
(taped to refrigerator door)
2. Using round head screws (provided with refrigerator), attach
the grille trim piece to the bottom of the grill panel.
NOTE: The grille trim is preinstalled on the panel kits.
B
A
B
Remove Trim Pieces
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer doors.
3. Remove the hinge cover trim pieces from the top and bottom
of the door to expose the holes in the hinges.
NOTES:
It is not necessary to remove the hinge side trims as they
will not interfere with the installation.
Leave the freezer drawer trims in place for installation.
A. Hinge cover pieces
B. Door adjustment pin cover
Install Drawer Panel
1. Align the slots in the door panel brackets, located on each
side of the drawer panel, with the holes that go through the
drawer trim and into the drawer.
2. Using Phillips-head flat screws (provided with refrigerator),
attach the brackets to the drawer.
3. Move the drawer panel up and down or from side to side to
align. Do not fully tighten the screws.
A
B
A. Drawer overlay panel
B. Drawer panel bracket
A
B
A
23