Jenn-Air JB36NXFXLW Installation Manual page 24

Install Door Panels
IMPORTANT: Use the foam packaging to prop and hold the
door(s) open while installing a door panel.
1. Align the two shoulder washers, on the back of the door
panel, with the "J" slots on the side of the refrigerator door.
Slide the panel onto the door.
A
A. Shoulder washer and hex head pointed screw
B. "J" slot
2. Lower the panel bracket down onto the adjustment pins at the
top of the door.
A. Door panel
B. Panel top bracket
3. French door models, repeat steps 1 through 2 to install the
second door panel.
4. Using slotted hex-head screws (provided with refrigerator),
attach the mounting bracket (factory installed), located at the
bottom of the refrigerator and freezer doors, to the respective
door panels. Do not fully tighten the screw.
A
A. Bottom hinge
B. Mounting bracket
24
B
A B
C
C. Adjustment pins
B
Install Top Grille Panel
B
A. Top grille panel
B. Cabinet sides
Standard Integrated Grille Installation—Flush Grille
1. Hook the panel brackets onto the mounting bolts extending
from the top of the refrigerator.
A. Panel brackets
B. Grill trim piece
2. Pull the grille panel down slightly to lock into place.
Fully Integrated Grille Installation—Full Height Grille
1. Align the bracket on each side of the top grille panel with the
mounting bolts.
2. Push the grille panel forward until the bracket snaps into
place.
A B
A
B