Table of Contents
Advertisement
To Unlock the door
To Unlock the door
10.1 DOLCSAW10KH operating as a Controller
DOLCSAW10KH
In this mode the
with a 26 bit output can be connected to the Wiegand input terminals on the
Either an ID card reader (125 KHZ) or an IC card reader (13.56 MHZ) can be connected to the
DOLCSAW10KH Cards are required to be added at the external reader, except where an external
ID reader is used, in this case cards can be added at either reader or controller. See figure 1
DOLCSAW10KH Controller
D0
D1
ALARM-
OPEN
D_IN
+12V
GND
VSS
L-
L+
ALARM+
10.2 DOLCSAW10KH operating as a Wiegand Output Reader
DOLCSAW10KH
In this mode the
lines can be connected to any controller which supports a Wiegand 26 bit input. See figure 2
10. Advanced Application
supports a Wiegand 26 bit input so an external Wiegand device
Figure 1
J1
Green
White
Grey
Yellow
Brown
door detecting switch
Red
Black
Blue
Purple
Orange
supports a Wiegand 26 bit output so the Wiegand data
Read User card
(Note that Manager Card can t be used as User Card
to unlock the door.)
Wiegand reader
Em card
GND
Ic card
+12V
HID card
D1
D0
reader plug
Alarm
exit btn
9
DOLCSAW10KH.
Power
DC12V/3A
Lock
Advertisement
Table of Contents
