Sound And Light Indication - Transmitter Solutions DOLCSAW10KH Quick Reference Programming Manual

Short Pin, then read the Two Manager cards (Manager add card firstly, Manager delete card
secondly), after that the LED turns red, which means the
default setting. Remarks: Reset to factory default setting, the users' information enrolled is still
retained. When re-set to Factory setting, the two Manager cards must be re-enrolled.
Operation status
Reset to factory default setting
Sleeping mode
Operation successful
Enter into programming mode
Enter into setting
Exit programming mode
Operation failed
Open the door
Alarm
9. DOLCSAW10KH Detailed Programming Guide
9.1 User settings
There are 2 ways to add and delete users:
A By manager card;
A - By Manager card (The most convenient way)
To Add user by Manager Add Card
To Delete User by Manager Delete Card
B- By Remote control
Enter into the programming mode firstly
To Enter the programming mode
Remarks: All the steps below must be done after enter into programming mode
To change the master code

8. Sound and Light indication

Orange blinks
Red flashes slowly
Red flashes
Orange flashes
Red flashes slow
Green flashes
Red flashes fast
- By remote control
DOLCSAW10KH has been reset to factory
LED
Two short ring
Short ring
Short ring
Short ring
Short ring
Three short ring
Short ring
Alarm
Manager add card Read card
card Cards can be added continuously.
Manager delete card
delete card Cards can be deleted continuously.
* Manager Password
888888 is the default factory master code
New Password #
0
The master code must be 6 8 digit number.
6
Buzzer
Manager add
Read Card Manager
#
Repeat New Password #