Programming Your Coffeemaker; Setting The Program Time - Cuisinart DGB-625C Series Grind & Brew Instruction Booklet

14
15
16
13
17
18
19
GETTING TO KNOW YOUR CONTROL PANEL
(Detailed programming instructions on page .)
Clock/LCD Display
Displays time of day and Auto On times.
On/Off button with LED Indicator
Manually turns coffeemaker on or off.
Audible Tone (not shown)
An audible tone sounds 5 times when brew
cycle is complete.
1-4 Cup Setting
Improves extraction, flavour and temperature
when brewing fewer than 5 cups.

14. Grinder Basket Lid
Use the recess on each side of the lid
to remove lid for easy addition of
beans.
15. Grinder Basket
16. Charcoal Water Filter
Charcoal water filter eliminates chlorine,
bad tastes and odours from tap water.
NOTE: Follow directions for preparing
and inserting filter on page 9.
17. Filter Basket Cover
To put on or remove, grasp cover in
area indicated by arrows. Cover
becomes hot after coffee is brewed.
Use caution when removing cover.
18. Gold Tone Commercial Style Filter
A note about filters: When using our
permanent filter, position handle toward
front of the unit so it does not interfere
with the flow of coffee into the filter
basket. Also note: using our permanent
filter may allow some fine coffee
grounds to fall into, and appear as
sediment in the carafe.
19. Filter Basket
Holds our commercial style permanent
filter or paper filter. NOTE: FILTER
BASKET MUST BE IN PLACE FOR
UNIT TO OPERATE CORRECTLY.
Removable for easy cleaning.
Hour and Minute Buttons
Use to program clock and Auto On
function.
Grind Off Button with LED Indicator
Turns off the grinder when using pre-ground
coffee.
Program Button with LED Indicator
Sets and/or displays programmed
Auto On time.
PROGRAMMING YOUR
COFFEEMAKER
SETTING THE CLOCK
When the coffeemaker is plugged in, 12:00
will appear until you set the time.
Entering Time Set Mode
Hold down the Hour or Minute button
until the clock begins flashing. Press
either button to select the desired
time. Hold buttons down to scroll
through the digits, or press and
release to advance one digit at a time.
When scrolling, the numbers will
advance slowly and then speed up.
When the number displayed approaches
the desired time, press and release to
advance one digit at a time. Be sure the
PM indicator is on if a PM time is desired.
Exiting Set Time Mode
a. Press any function button besides Hour
or Minute to exit mode.
b. If you do nothing for a period of five
seconds the mode will be exited.

SETTING THE PROGRAM TIME

When you press the Program Set button,
it displays a previously selected auto-on
time, or the default time (12:00pm).
Entering Set Program Time Mode
Press and hold the Program set
button until the green light and LCD
display begin to flash. You are now in
Set Program Time mode. Set the time
you want coffee to begin brewing by
following the instructions in "Entering
Time Set Mode."
The coffeemaker will start to brew at the
programmed time. The Program mode
cannot be entered if the coffeemaker
is in its brew cycle.
Exiting Set Program Time Mode
a. Press and release Program button.
b. Press any function button besides
Hour or Minute to exit mode and
activate the selected function.
c. If you do nothing for a period of five
seconds the mode will be exited.
SETTING THE AUTO
SHUTOFF TIME
The automatic shutoff time (ASO) can be
programmed to shut off immediately after
brewing (0:00) or up to 4 hours later. The
default shutoff time is 2 hours.
Press and hold the On/Off button to display
current shutoff time. To change the preset
time, press and hold the On/Off button until
the red power light and LCD display begin to
flash. This signals that you have entered the
set automatic shutoff mode. Set the time you
want coffee to begin brewing by following
the instructions in "Entering Time Set Mode."
When the coffeemaker shuts itself off, two
tones will sound.
NOTE: Automatic shutoff may be
programmed either before or during coffee
brewing. If you program the auto shutoff
time after brewing is completed the unit
will automatically account for elapsed time.
For example, if you set the auto shutoff for
40 minutes and 25 minutes have already
elapsed, the unit will shut off automatically
after 15 minutes (40 minutes minus the 25
elapsed equals 15 minutes).