Tiger PDU-A30U User Manual page 12

3
Boiling Water
6
Select [Keep Warm]
Press Temp.Set key.
■Keep Warm temperature
208
(approx.208°F)
176
(approx.176°F)
Temp.Set
Each press of
temperature setting as shown.
Light
illuminates
• You can change temperature setting during Boiling
cycle or Keep Warm.
If the power cord comes off during the
Caution
temperature setting, the setting is not completed.
It will go back to default setting. (194)
■During the boiling cycle
Current water temperature
Flashing
※ Timing to start displaying remaining time will vary depending on
the amount of water and the water temperature.
※ Water temperature will be displayed by every 9°F. (If it is
approximately 208°F, it will display "208".)
7
Automatically set to warmer
■When boiling
Light
illuminates
Light
turns o
■When water temperature reaches setting temperature...
• Do not come in contact with the steam to
Caution
avoid being scalded.
• Do not open or close the lid with excessive
force and do not dispense hot water during
the boiling cycle or immediately after boiling.
Failure to do so may cause scalds due to hot
water splashing or steam being emitted.
11 11
. 194 .
(approx.194°F)
.158 .
(approx.158°F)
key changes different
Flashing
Beeping
sound
Remaining time until boiling
Flashing
Beeping sound
(repeats 5 times)
Light
illuminates
Beeping
sound
Time table for Boiling and Cooling
Boiling from cold water
From boiling to reach 194
warmer temperature
From boiling to reach 176
warmer temperature
From boiling to reach 158
warmer temperature
※ Under these conditions: full water volume, the water temperature /
room temperature is 73°F, and voltage is normal rated voltage.
※ Guidelines for the time required to reach the 208 warmer temperature
are almost the same as those for boiling from cold water.
To re-boil during the Keep Warm cy-
cle. Press
Re-Boil/Timer
Be sure the water level is above Refill water mark.
Beeping
sound
Light
illuminates
Guidelines for the time required for re-boiling
when the water is at the full water level
Warmer temperature at 208, 194
Warmer temperature at 176
Warmer temperature at 158
※ Adding water or reattaching the power cord during Boiling cycle,
boiling time may extend.
■To reduce chlorine smell during Keep
Warm cycle.
Press the Re-Boil / Timer key twice.
Press the
Beeping Beeping
sound sound
Flashing
Press Re-Boil / Timer key and scroll through the option
until you reach your preferred option cycle.
※ Be sure to check the display panel for your preferred cycle. It
uses both Re-Boil / Timer key and [Power-Saving Timer]
3.0L Type 4.0L Type 5.0L Type
Approx.24
Approx.31 Approx.41
minutes minutes minutes
Approx. Approx. Approx.
1 hour and 1 hour and 1 hour and
5 minutes 5 minutes 15 minutes
Approx. Approx. Approx.
2 hour and 2 hour and 2 hour and
25 minutes 35 minutes 50 minutes
Approx. Approx. Approx.
4 hour and 4 hour and 4 hour and
10 minutes 30 minutes 55 minutes
key once.
Flashing
3.0L Type 4.0L Type 5.0L Type
Approx.4-8 Approx.5-9 Approx.5-10
minutes minutes minutes
Approx.9-11 Approx.10-12 Approx.13-15
minutes minutes minutes
Approx.11-13 Approx.13-15 Approx.17-19
minutes minutes minutes
key twice.
Flashing