Table of Contents
Advertisement
1. Cable connection
*USB interface scanner installation
Make sure that the scanner has the correct cable for your system. Connect the
cable to the USB port of the PC or POS.
*RS-232C interface scanner installation
Make sure that there is a power supply to the scanner (If necessary). Some
th
devices deliver power through serial port using SUB D9 connector on 9
pin
(Chapter 20)
Connect the cable to the RS-232C port of the PC or POS. Make sure that host
device should have communication program (Xcom, procomm, Hyperterminal)
before transmitting data.
Note: Use only connection cables that are packed with LBR 100 scanner.
2. Scanner handling
Manual activation. Aim the scanner at the bar code. Press and hold the button
down to activate scan and transmit the bar code. After successful reading of
bar code audible feedback will indicate status, along with the light indication.
- 7 -
Advertisement
Table of Contents
