MAKINEX DPW-2500 Operator's Manual page 18

WHEN ADDING FUEL TO PRESSURE WASHER, OBSERVE THE FOLLOWING
STEPS:
2.1 Turn pressure washer OFF and let it cool for at least two minutes before
removing fuel cap. Loosen fuel cap slowly to release pressure.
2.2 Fill fuel tank outdoors.
2.3 DO NOT overfill fuel tank. Leave room for fuel to expand.
2.4 Wait for spilled fuel to evaporate before cranking engine.
2.5 Keep fuel away from sparks, open flames, pilot lights, heat and other ignition
sources.
2.6 DO NOT light a cigarette or smoke near open fuel tank or container.
2.7 Clean area around fuel fill cap and slowly remove cap to allow any pressure to
escape.
2.8 Slowly add unleaded gasoline (A) to fuel tank (B). Use extreme caution not to
fill fuel above baffle (C).This allows appropriate space for fuel expansion.
2.9 Install fuel cap and allow any spilled fuel to evaporate before starting engine.
Page 18 of 54