Control And Indicating Equipment; Control Panel; Repeat Panels - Gent Nano Operating Instructions Manual

Control and indicating equipment

On occurrence of a fire, fault or disablement event in the protect premises, the event is quickly indicated at the
control panel. The panel controls are password protected and must only be operated by the person responsible
for the fire system.

Control panel

The control panel is the heart of the system. It is normally located near to the main entry or exit point of the
protected premises. The control panel continuously monitor devices that are connected to the device loop. The
device loop cable is routed through the protected premises to cover all areas with both ends of the loop
terminating at the control panel. On the loop cable are installed devices such as fire sensors that constantly
monitor the environment for fire. Alarm devices on the loop provide alert and evacuation alarm to warn
occupants in the protected premises in the event of a fire.

Repeat panels

There may be one or more repeat indicator panels installed in the protected premises to provide secondary
indications of the system events. The repeat indicator panels are usually located near to secondary entry and
exit points of the protected premises.
Repeat indicator panel
Cancel Sound Silence
Buzzer
Alarms Alarms
Reset
Disablement Test Delay
System Fault Power Fault
Sounder Fault
Zone 3
Zone 1 Zone 2
Zone 5 Zone 6 Zone 7
Zone 9 Zone 10 Zone 11
Zone 13 Zone 14 Zone 15
FAULT POWER FIRE
by Honeywell
042bc
Display
Menu navigation controls
Emergency controls
Fault, disablement and
Verify
Sounder
Disablement
status indicators
Zone 4
Zone 8
Zone 12
Zone indicators
Zone 16
Common indicators
EN54 Parts 2 & 4
NANO fire system
5