MTX Thunder sports MUDSYS41 Owner's Manual

Bluetooth overhead audio system

Advertisement

OWNER'S MANUAL
MUDSYS41 / MUDSYS46
BLUETOOTH OVERHEAD AUDIO SYSTEMS
M T X . C O M

Advertisement

Table of Contents
loading

Summary of Contents for MTX Thunder sports MUDSYS41

  • Page 1 OWNER’S MANUAL MUDSYS41 / MUDSYS46 BLUETOOTH OVERHEAD AUDIO SYSTEMS M T X . C O M...
  • Page 2: Important Notice

    IMPORTANT NOTICE Installation of overhead products requires careful planning and preparation. If you have any questions regarding wire routing in a vehicle, please contact MTX Technical Support at 1-800-225-5689. When connecting power and ground wires ensure that the yellow power wire is fused at the point where it is connected to the vehicle’s battery.
  • Page 3 INTRODUCTION Thank you for purchasing this MTX Audio Bluetooth Overhead Audio System that is designed to deliver exceptional quality music to your off road vehicle. This easy to install and use all in one unit is capable of withstanding the wind, sun, rain, and more ensuring that you can enjoy it wherever life takes you.
  • Page 4 SOURCE UNIT BUTTON LAYOUT 1. Power / Mute Button - Press the button to turn power On. When the power is On, press the button to mute the audio output. Press and hold the button to turn power Off. 2. + Button - Press the button to increase the volume. 3.
  • Page 5: Settings Menu

    • Press MODE for 2 seconds, BT PLAY will be displayed. • Hold MODE for 2 more seconds and “Pairing” will be displayed. • Select “MTX SOUNDBAR” from the list of available Bluetooth devices. • The device will then pair to the unit.
  • Page 6: Clock Operation

    CLOCK OPERATION Press and hold the “Band” button for 2 seconds to display the clock. When displayed, press and hold the “Band” button for 2 seconds until the hour number is flashing, then use the +/- buttons to adjust the hour. Once set to desired number, press the “Band” button again and the minutes number will flash.
  • Page 7: Troubleshooting

    Remove the bolts from the C-bracket so the top bracket and C-bracket can be properly positioned around the roll cage. Once the C-brackets are in the proper location for mounting, the bolts should be retightened to a torque specification of 65-70 inch/lbs. The unit has an integrated wiring harness that includes a power, ground, and accessory wire that are designed to connect to the vehicle’s battery providing it power.
  • Page 8 © 2014 Mitek Corporation. All rights reserved. MTX is a trademark of Mitek Corporation. Designed and Engineered in the U.S.A. Due to continual product development, all specifications are subject to change without notice. MTX Audio, 4545 East Baseline Rd. Phoenix, AZ 85042 U.S.A. 1-800-225-5689 MTX005072 RevA 12/14 •...

This manual is also suitable for:

Thunder sports mudsys46

Table of Contents