Clock Operation; Installation - MTX Thunder sports MUDSYS41 Owner's Manual

CLOCK OPERATION

Press and hold the "Band" button for 2 seconds to display the clock. When displayed, press and hold
the "Band" button for 2 seconds until the hour number is flashing, then use the +/- buttons to adjust
the hour. Once set to desired number, press the "Band" button again and the minutes number will
flash. Use the same process to set the minutes to desired number.

INSTALLATION

The MUDSYS41 and MUDSYS46 will mount to a variety of roll cages that have a diameter between
1.75" and 2". Installation is a two part process. Part one involves securely mounting the unit to the roll
cage and part two involves connecting the wiring to the vehicle's battery.
Each unit comes preassembled in the carton. Each end
has a top side flat bracket and an underside C-clamp
designed to lock the unit into place between the roll
cage. Each top bracket has four (4) total bolts.
When the bolts are loosened, the bracket can slide
to accommodate a variety of roll cages whose inside
roll bar dimension is between 43.0" and 49.0" for the
MUDSYS41 and 49.25" and 56.0" for the MUDSYS46.
Once the proper width has been established, these
bolts should be retightened to a torque specification
of 40-45 inch/lbs.
Each C-bracket has two (2) total bolts. These bolts can be loosened to adjust the clamp angle
allowing it to mount to a variety of roll cages including those that are angled.
6
M T X . C O M