Wiring Identification - JBL MR-32 Operation Manual

Wiring Identification

B
C ( Remote control )
( SIRIUS control )
F
( AUX-IN )
D
(CD changer socket)
E
(ANT. socket)
CONNECTOR
FUSE
Blue
(AUTO ANT) 1A
FUSE
Yellow
( BACK-UP B+ )
10A
Black
( GROUND )
Red
( IGNITION B+ )
White
( Front Left )
White/Black
Green
( Rear Left )
Green/Black
Installation Notes
Applicable to both 2 and 4-speaker connection:
A. Connections
B. Din cable connection for remote control
C. Din cable connection for SIRIUS control
D. CD change socket
E. Antenna socket
F. AUX-IN
This radio contains four separate power amplifiers. To prevent possible damage to
these amplifiers, please ensure the following:
i) The boat chassis is not used as a loudspeaker ground(-).
ii) Front and rear loudspeaker connecting wires are not joined together.
iii) Any wires not used when completing a two speaker installation are fully insulated.
iv) The memory wire (yellow) is connected to a permanent + 12V supply.
v) The power wire (red) is connected via the ignition switch of the boat.
2
145x210mm
A
Red
Gray
Rear Line out
White
Red
Black
Front Line out
Gray White
( Front Right )
Gray/Black
Violet
( Rear Right )
Violet/Black
Precautions and Maintenance
CD slot
1. Reset function
A microprocessor reset button has been provided to facilitate manual resetting of the
internal microprocessor in the unlikely event that the player fails to operate correctly.
Should it be necessary to reset the microprocessor, simply open the face, remove
rubber plug and press reset button.
Note: It will be necessary to re-enter the radio preset memories as these will have
been erased when the microprocessor is reset. After resetting the player, ensure
that all functions are operating correctly.
2. General Precautions
If the unit has become extremely hot, we strongly recommend that you allow it to cool
down before using. Take care of your CDs to preserve the quality of the recording.
Do not allow them to be exposed to direct sunlight. Store them in a place protected
from dirt and dust and avoid handling them with oily, greasy or wet hands.
Be sure the CD is put into the CD slot label side up.
3. Caution
CONNECTOR PIN: Always keep connector pin clean.
If the PIN connector looks dirty, use cotton tips to clean it, so as to avoid any
unexpected malfunction caused by dirt.
CD EJECT button
Connector pin
11