This product is sold and serviced exclusively by Prospec Electronics Inc. and must be returned to Prospec for in and out of warranty repairs. It can not be serviced under warranty by other JBL service centers. All products sold and serviced exclusively by Prospec Electronics Inc.
Page 2
Quick Reference Guide for Sirius 1. To Access Satellite Radio (perform one of the following) - Press MODE button until SIRIUS appears on the LCD. - While in any mode other than SIRIUS, simply press SH.SR to enter SIRIUS mode. 2.
Trouble shooting guide Contents INTERFERENCE ON RADIO Contents Poor atmospheric conditions - Try again later in the day Antenna / lead broken or damaged Wiring Identification DISTORTED AUDIO Opening and closing the front panel Check loudspeaker wiring Important Notes This product contains a biamp. It is important not to connect the front loudspeaker ground to the rear speaker ground.
Wiring identification Precautions and maintenance ( Remote control ) ( SIRIUS control ) CD eject button CD slot ( AUX-IN ) Front panel (ANT. socket) Connector pin CONNECTOR 1. Reset function A microprocessor reset button has been provided to facilitate manual resetting of FUSE Blue the internal microprocessor.
Page 5
Operating the CD Opening and Closing the front panel To change or replace the CD, press release button the front panel will open (flip down), then press the EJ button to eject the CD. MUTE MUTE Release button MARINE MUTE MUTE MARINE 1.
Important notes Station Tuning Prior to the final installation, carry out a sound check. If high distortion or intermittent sound is experienced, it is possible that the wiring from the CD receiver to the boat's electrical system is poor or that the battery needs recharging. If the battery and its charging circuit are OK, then rewire the yellow fused wire of the MUTE MUTE...
Page 7
Controls Identification of controls and functions 8.DISP (17) 1) Press once to see clock , press again to turn back to the radio frequency. On the SIRIUS mode , it works as preset #8. 2) Adjust the clock / time a.
Page 8
Controls Controls a. Beep 2nd On the beep 2nd, you can control the Beep on or Beep 2nd by turning the spindle knob. - Beep on: You can hear beep sound when you press all buttons. - Beep 2nd: You can hear beep sound when you press the button over 1.5 seconds.
Need help?
Do you have a question about the Marine MR-18.3 and is the answer not in the manual?
Questions and answers