Summary of Contents for Audio international AI-ST100X
Page 1
Guide to Installation & Operations Stereo Power Amplifier Model #: AI-ST100X Document #540048 7300 Industry Drive, North Little Rock, AR 72117 Phone: 501-955-2929 Fax: 501-955-2988...
AUDIO INTERNATIONAL, INC. 10.98 Service Bulletin List Service Subject Manual Manual Bulletin # Revision Revision Date List of Illustrations Section Description Page # Number Simplified internal block diagram Document #: 540048 Rev. IR, Model No.: AI-ST100X...
PROPRIETARY NOTICE: Despite any copyright notice, the data and information disclosed herein is unpublished and contains confidential, proprietary design owned by Audio International Incorporated. Neither this data nor the data contained herein shall be reproduced, used or disclosed to anyone without the written authorization of Audio International Incorporated.
Purpose of the Equipment The AI-ST100X is an audio component that can be utilized to form standard, basic building blocks that can be arranged in almost any configuration for any size aircraft. The audio components are built to rugged aircraft standards and are easily incorporated into new or existing cabin audio systems.
Installation Prior to Installation The AI-ST100X is a simple module to use and install. All audio input cables should be 24 AWG minimum twisted shielded pair and output cables should be 20 AWG minimum (16 – 18 AWG recommended) twisted shielded pair.
Cautions & Warnings 2.3.1 All audio connections to the AI-ST100X should be shielded and grounded. Perform a pin-to-pin check to confirm that all wires terminate in their proper location. It is important to do a power and ground check on the pin connections.
Physical Requirements 2.5.1 Refer to Section 5.0 for unit dimensions and attachment points. 2.5.2 The AI-ST100X must be located in a position that is easily accessible as adjustments are located at the back of the unit. Therefore, allow enough clearance for gain adjustments.
(Left and right audio controls). Operations To operate the AI-ST100X, load the audio source with selected material. Adjust the gain controls to desired options. Troubleshooting Guide Problem...
1 AMP each (Do Not exceed total combined current rating of 3 AMPs. Amplifier 5 AMP Fuse +12 VDC supply on 3 AMP Fuse Applicable Drawings: 5.2.1 The following diagram shows the unit dimensions and connector locations. Document #: 540048 Rev. IR, Model No.: AI-ST100X...
Page 11
AUDIO INTERNATIONAL, INC. 10.98 Document #: 540048 Rev. IR, Model No.: AI-ST100X...