Advertisement
Quick Start Guide
Assembly
Quick Prep Steps
Guidelines to Spot Clean
Cleaning Formula
1. Slide flex hose clip into the opening on the
front of the machine until you hear a "snap."
2. Snap the hose grip bracket into the back of
machine on the clean tank side. Wrap flex hose
around unit and snap hose grip into bracket.
3. Attach cord wrap by snapping it into place
on the dirty water tank side of the machine.
Wrap power cord around cord wrap.
1. Unwrap hose and select desired tool.
Tool easily snaps onto hose.
2. Remove tank from tool side of unit. Pull on
the black tab to remove rubber stopper and
reveal tank opening.
3. Follow the fill lines on your Clean Tank to
add the correct amount of water and 1 oz of
CHAMBERLAIN or BISSELL Formula. DO NOT
BOIL OR MICROWAVE WATER.
4. Replace rubber stopper, then replace the tank
on the machine.
5. Twist the quick release cord wrap to
release the cord, plug in, and you're ready
to spot clean!
1. Hold the 3" Tough Stain Tool 1 inch above soiled
surface and press spray trigger to apply cleaning
formula. When using the Deep Stain Tool, set the tool
directly on top of the carpet before pulling the spray
trigger to inject formula deep into your carpet fibers.
Always keep the tool in direct contact with carpeting
to avoid over-spraying.
2. Gently scrub the area with brush on tool.
3. Apply downward pressure to the tool and pull it
toward you to suction up the dirt and cleaning
formula. Continue until no more dirt can be removed.
›› Always use genuine CHAMBERLAIN or BISSELL
portable deep cleaning formulas. Non-
CHAMBERLAIN or non-BISSELL cleaning solutions
may harm the machine and will void the warranty.
3
Advertisement
