About The Front Bezel (With Lcd Component); Replacing The Front Bezel - F5 Viprion Manual

3. Grasp the ejector handle and remove the fan tray from the chassis by pulling straight toward you.
4. Place the new fan tray into the fan tray bay.
5. Remove the fan tray from the system by pulling straight toward you.
6. Push the fan tray into the chassis until it is seated firmly in the fan tray bay.
Once seated, the fan tray automatically powers up and begins circulating air through the chassis.
Important: Use only the fan tray handle to seat the fan tray in the chassis. Using the edges of the fan
tray could result in pinched fingers, as a fully-seated fan tray is nearly flush with the other chassis
components.

About the front bezel (with LCD component)

The LCD component on the front bezel enables you to access several functions associated with the platform, such as
configuring the management port for the system.

Replacing the front bezel

You can replace the front bezel in the unlikely event of an LCD component failure. You do not need special tools to
replace the front bezel.
1. Remove the original front bezel by grasping the bezel on either side, using the indentations provided.
Note: Failure to use the indentations could result in pinched fingers.
2. Pick up the replacement front bezel using the indentations provided.
3. Align the guide pins on the bezel to the corresponding holes in the chassis.
Platform Guide: VIPRION | Platform Maintenance | 43