Steam Cleaning Floors - Morphy Richards Multi Floors User Manual

VC720505MUK Rev1_Instruction Book 07/11/2013 09:54 Page 4
Assembly
Insert the handle tube
(10) until it clicks into place.
If you wish to remove the handle
handle tube), press the handle tube release
button (11) and lift the handle and tube out.

Steam cleaning floors

IMPORTANT: Before use, hardfloors should be thoroughly swept and carpets should be thoroughly dry
vacuumed. However, we recommend that the steam mop is not used on:
• bare wooden floors or any surfaces where wood is exposed (as it will absorb moisture and may distort).
• damaged hardfloors or hardfloors with gaps present (as it will absorb moisture and may distort).
Also, do not keep the steam mop in one place for an extended period, because the continual heat may
cause damage to carpets and laminate flooring.
Please disconnect and allow the unit to cool before changing cloths.
Attach the micro-fibre floor cloth
floorhead (23), securing it in place by tightening
the toggle (5).
NOTE: Please ensure the unit is switched off
and has cooled down before attempting to
adjust or remove cloths.
4
1
(8) into the handle slot
(1) (with the
1
(6) to the
Insert the floorhead (23) onto the main body
by aligning the floorhead neck
steam outlet on the base on the main body. Push
on firmly until it clicks into place.
If you wish to remove the floorhead, press the
floorhead release button (22)
floorhead away.
If cleaning carpet, rest the floorhead
the micro-fibre floor cloth (6)
carpet glider (7) to make it easier to move the
floorhead across the carpet.
NOTE: The carpet glider is designed to make it
easier to move the floorhead across the carpet
and is intentionally a loose fit on the floorhead.
2
(20)
(21) onto the
and pull the
2
(23) with
attached into the