Using The Repeater; How It Works - Uniden XDECT R001 Owner's Manual

How it Works

The XDECT R001 repeater works to extend the range of the XDECT
R055, XDECT R035, Elite 9035BT or Elite 9045BT base in just the
same way as the repeater/charger unit. The only difference is the
XDECT R001 repeater and handset-charger are separate units.
Refer to your Base owner's manual for more information on how
repeaters work.
To use the repeater function, you must register the repeater to

an XDECT R055, XDECT R035, Elite 9035BT or Elite 9045BT
base. (Any repeaters that came packaged with the base are
already registered to that base for you.)
An XDECT R055, XDECT R035, Elite 9035BT or Elite 9045BT

base can support up to six repeaters, including any that were
supplied with your phone.
Usually, you can't tell when a handset switches between the

base and the repeater in the middle of a call, but sometimes, you
might notice a brief pause in your conversation.
Repeaters can be up to 3 chain-links (maximum) from the base.

Connect the Repeater
Remove the repeater Plug Cover from the plug section.

Connect the AC adapter to the repeater's

route the cord (This adapter might already be connected).
Place the repeater Plug Cover over the plug section and slide

into place. Plug the other end of the adapter into a standard
240V AC power outlet.

Using the Repeater

DC IN 9V jack and
3