Normal Operation; Channel Selection; Volume Adjustment; Signal - LG LST-3100A Owner's Manual

Normal Operation

– (dash) button
Number buttons
SELECT SELECT
MUTE FLASHBK
PG UP PG UP
PG DN PG DN
RATIO FREEZE SURF HELP
SURF ( ) button
CH +/– buttons
FLASHBK button
MUTE button
VOL +/– buttons
MUTE FLASHBK
PG UP PG UP
PG DN PG DN
RA O TIO FREEZE SURF HELP
SIGNAL button
AUDIO CC

SIGNAL

FREEZE button
RATIO FREEZE SURF HELP
ST STATION TION
PROGRAM
38

Channel Selection

You can select a channel as shown below.
Number and – (dash) buttons (on the remote control)
Use Number (0-9) and – (dash) buttons to select a channel directly.
FLASHBK button (on the remote control)
Press to return to the previous channel you viewed. For example, if the
DTV Receiver is tuned to channel 55 and then you change to channel 56,
pressing FLASHBK will return to channel 55.
SURF ( ) button (on the remote control)
Press to scroll through your favorite channels.
CH +/– buttons (on the remote control) or 3 / 4 (on the front panel)
Use CH +/– on the remote control or 3 / 4 on the front panel to cycle the
HDTV Receiver through the channels in memory.

Volume Adjustment

Adjusts the volume of analog audio out on HDTV Receiver. You must set
Audio Variable to On in the OPTION menu to use the Volume Adjustment.
See page 24.
VOL +/– buttons (on the remote control) or 1 / 2 (on the front panel)
Use VOL +/– on the remote control or 1 / 2 on the front panel to adjust
the volume for analog audio out on the HDTV Receiver.
MUTE (on the remote control)
Press MUTE to turn off the volume for analog audio out on the HDTV
Receiver.
otes
• Before setting Audio Variable to Off, make sure that you have turned down the TV's
volume to the minimum. Otherwise, sudden high volume sound may cause hearing
or speaker damage.
• The volume of digital audio out on HDTV Receiver can not be adjusted on the
HDTV Receiver front panel.
Signal
Shows the signal strength bar for incoming signal to help you adjust the
antenna to the correct position for your location. You can view the signal
strength bar by pressing SIGNAL on the remote control.
ip
Refer to www.antennaweb.org for antenna position.
AntennaWeb.org, will help you determine the proper outdoor antenna to use
in order to receive television channels that are broadcast locally.

Freeze

Pressing the FREEZE button freezes the current image. Pressing the
FREEZE button once again returns the image to live video.
ote
The frozen image returns to live video after 5 minutes.