Table of Contents
Advertisement
Connections (Continued)
Display Formats Overview
The HDTV Tuner offers various display formats and multiple video outputs. When the HDTV Tuner is connected
•
to A/V systems, the HDTV Tuner can provide video signal formats 1080i, 720p, 480p, and 480i.
1080i, 720p, 480p, and 480i modes are available for component video (YPbPr) outputs.
•
1080i, 720p, and 480p modes are available for RGB and DVI outputs.
•
480i mode is available for VIDEO, S-VIDEO, and COMPONENT VIDEO outputs.
•
The HDTV Tuner has two digital audio outputs; Dolby Digital 5.1 and PCM. The HDTV Tuner sends out a digital
•
audio signal to OPTICAL and COAXIAL audio outputs when digital broadcasts are being received by the HDTV
Tuner.
Analog Monitor Connections
Antenna
Wall Jack Panel
OR
Connect the "Antenna/Cable" to the "ANT IN" jack on the HDTV Receiver using a coaxial RF cable.
1
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to an attenuator. Screw the attenuator onto the "ANT IN" jack. (Refer to page 9.)
Connect the "ANT LOOP OUT" jack on the HDTV Receiver to the "Antenna In" jack on your TV using a coaxial
2
RF cable.
Connect the "AUDIO OUT" and "VIDEO OUT" jacks on the HDTV Receiver to the "A/V IN" jacks on your TV
3
using RCA-type cables. If your TV is equipped with an S-Video jack, use the S-VIDEO OUT jack.
(The Output Selection must be set to YPbPr, refer to Setting the Display Format on page 16)
ote
These connections are only useable if the display format settings are set to 480i and YPbPr. (Refer to page 16.)
10
Cable TV
TV Connection Panel
ANTENNA
AUDIO INPUT
INPUT
R
L
To AUDIO OUT
HDTV Receiver Connection Panel
VIDEO
S-VIDEO
INPUT
INPUT
L
OR
Advertisement
Table of Contents
