Operating Range For The Optional Remote Control - NEC MultiSync X464UN User Manual

PIP (Picture In Picture) button
ON/OFF button: Toggle switches between PIP, POP,
PICTURE BY PICTURE-ASPECT and PICTURE BY
PICTURE-FULL. See page 22.
INPUT button: Selects the "picture in picture" input signal.
CHANGE button: Replaces to the main picture and sub
picture.
NOTE: Enable to change the sub picture size by pressing
SET/POINT ZOOM button during PIP mode.
Main picture Connector
3
DPORT* DPORT* DVI DVI
DPORT DPORT DisplayPort DisplayPort No No Yes Yes
DVI DVI DVI-D DVI-D Yes Yes No No
HDMI HDMI HDMI HDMI Yes Yes Yes Yes
VGA VGA Yes Yes Yes Yes
D-Sub* D-Sub* 4
Y/Pb/Pr Y/Pb/Pr Yes Yes Yes Yes
OPTION OPTION Option Option Yes Yes Yes Yes
*3: When VIDEO OUT SETTING is ON, DPORT cannot be selected as the sub picture. *3: When VIDEO OUT SETTING is ON, DPORT cannot be selected as the sub picture.
*4: If VGA or Y/Pb/Pr is selected as the main picture, DP out is disabled even when *4: If VGA or Y/Pb/Pr is selected as the main picture, DP out is disabled even when
VIDEO OUT SETTING is ON. VIDEO OUT SETTING is ON.
*5: DP out can output signal only when VIDEO OUT SETTING is ON. *5: DP out can output signal only when VIDEO OUT SETTING is ON.
REMOTE ID button
Activates REMOTE ID function.
MTS button* 1
1
button*
Activates closed captioning.
2 2
NOTE: VIDEO* , S-VIDEO*
*1: This button's action depends on which option board you use.
Refer to the option board's manual for further information.
*2: This function depends on which option board you use.
Sub picture
DP Out*
HDMI HDMI VGA VGA Y/Pb/Pr Y/Pb/Pr OPTION OPTION
Yes Yes Yes Yes Yes Yes Yes Yes DPORT DPORT
Yes Yes Yes Yes Yes Yes Yes Yes DVI DVI
No No Yes Yes Yes Yes Yes Yes HDMI HDMI
Yes Yes No No No No Yes Yes
Yes Yes No No No No Yes Yes
Yes Yes Yes Yes Yes Yes No No OPTION OPTION
inputs only.
Operating Range for the Optional
Remote Control
Point the top of the remote control toward the sensor unit's
remote control sensor in optional control kit during button
operation.
Use the remote control within a distance of about 7 m (23 ft.)
from remote control sensor or at a horizontal and vertical
angle of within 30° within a distance of about 3.5 m (10 ft.).
5
-
-
Caution: Important, the remote control
Handling the remote control
• Do not subject to strong shock.
• Do not allow water or other liquid to splash the remote
control. If the remote control gets wet, wipe it dry
immediately.
• Avoid exposure to heat and steam.
• Other than to install the batteries, do not open the remote
control.
English-11
system may not function
when direct sunlight or strong
illumination strikes the remote
control sensor or when there is
an object in the path.