Pace DC60Xu Quick Start Manual page 11

STANDARD-DEFINITION CONNECTION
1. Connect the supplied coxial RF cable from the cable service to the
connector marked CABLE IN on your digital adapter, as shown below.
2. Connect another coxial RF cable between the TO TV connector on your
digital adapter and the ANTENNA IN/RF IN connector on your SDTV.
3. Connect the external power supply unit (supplied) to the connector
marked POWER on your digital adapter.
4. After you have made the connections between your digital adapter
and your SDTV, connect your SDTV and the external power supply
unit to the AC power supply.
5. Make sure your TV is tuned to channel
3, and set the switch on the back of
your digital adapter to channel 3.
Note: Some parts of the country use
channel 4. If you do not have a picture,
you may need to switch both your TV
and digital adapter to channel 4.
Digital Adapter
From your cable service
Supplied RF cable
RF cable
Set this switch to Channel 3
CABLE IN
RF IN
SDTV
To the wall
AC outlet