Hanging The Fan Body; Making The Electrical Connection; Install Ceiling Canopy - CONCORD RM-08 User Manual

Receiving
Unit
Figure 5
Black
Blue
White
Orange
Blue
or Gray
Figure 6a - Fan with Uplighting
Black
Blue
White
Orange or
Blue
Gray
(Cap OFF)
Figure 6b - Fan with no Uplighting (Cap OFF)
Figure 7
STEP 6: Hanging the fan body
Mounting
Bracket
Notice the half ball on the end of the support rod is grooved down one side.
This Keyway fits over the small keyway pin on the inside of the mounting
bracket and keeps the ceiling fan from spinning on the mounting bracket.
Lift the fan and place the half ball in the center of the mounting bracket with
the keyway pin inserted into the keyway on the ball. Turn the fan left and
Support
Rod right slightly to make sure it is seated on the bracket with the keyway pin in
the keyway (see figure 5).
Trim the lead wires, leaving about six (6) inches of each wire extending from
the support rod.
Ground
Black
White
STEP 7: Making the electrical connection
TURN OFF THE ELECTRICITY BEFORE PROCEEDING!
Make electrical connections from the fan to receiving unit in mounting bracket
(see figure 6a and 6b).
Ground
-Attach the WHITE wire from the fan to the WHITE wire from receiving unit.
-Attach the BLACK wire from the fan to the BLACK wire from receiving
unit.
-Attach the BLUE wire from the fan to the BLUE wire from receiving unit.
Ground
NOTE:
Black
-If your fan has uplighting you will have an ORANGE or GRAY (on some
models) wire coming out of the fan. Connect this ORANGE or GRAY wire
White
from the fan to the ORANGE or GRAY wire on the Receiving Unit (see
figure 6a).
-If your fan has NO Uplight, cap off the ORANGE or GRAY wire from
receiving unit (see figure 6b).
Position the receiving unit inside of the mounting bracket and feed the 4 wires
from the receiving unit down through the mounting bracket (see figure 5).
Ground
Ceiling
STEP 8: Install Ceiling Canopy
Mount
Bracket
Lift the ceiling canopy up into place covering the mounting bracket.
Canopy
Push the canopy up so the screws come through the mounting holes in the
canopy. Rotate the canopy slightly and tighten the screws (see figure 7).
Canopy
Screw
- 5 -