Option To Remove Wiring From Switch Housing - CONCORD RM-08 User Manual

Screw (3)
Molex
Sleeve
Figure A
Screw (3)
Pigtail Connector
Sleeve
Figure B
Plug
Figure C
- Unscrew the metal sleeve where the pull chain comes out of the switch
Mounting Plate
housing (see figure A).
-Remove the speed switch from the hole.
-Next, remove the 2 small screws holding the forward/reverse switch in
Reverse
place (see figure A).
Switch
Screw (2)
-Now remove the forward/reverse switch from the hole.
-You are now able to remove the entire contents of the switch housing
unit (see figure C).
Switch
Housing
-Place the plastic caps supplied into the holes left by the speed switch
and forward/reverse switch (see figure C).
Mounting Plate
Molex
NOTE: If your fan has uplights or motor center band lighting, your
Reverse
Switch
switch housing will look like figure B.
Screw (2)
Switch
Housing
Remove Wire Bundle
Plug
Switch Housing
- 2 -

Option to remove wiring from switch housing