Table of Contents
Advertisement
DVG-5102S User's Manual
Select a PPPoE
After entering IVR mode, dial 114.
When voice prompt plays "Enter value," dial 3 (to select PPPoE).
PPPoE Account Settings
After entering IVR mode, dial 121.
When voice prompt plays "Enter value", enter the account number followed by"#".
Example: If the account is "87654321@hinet.net," please enter 08 07 06 05 04 03 02 01 71 48 49 54 45
60 72 54 45 60 #.
Note: It is necessary to enter two digits for each alphabet/number; for example, you must enter "01" for
"1" and "11" for "A". Using the web Interface to configure your PPPoE account details is recommended.
Refer to the PPPoE Character Conversion Table on the next page for key mappings if you choose to
use IVR setup.
PPPoE Password Setting
After entering IVR mode, dial 122,
When voice prompt plays "Enter value," enter the new password followed by "#".
Example: If the password is "3t2ixiae", please enter "03 60 02 49 64 49 41 45#".
Save Settings and Restart
To save settings, dial 509 (Save Settings). The system will save the settings. Please restart the system.
Wait for about 40 seconds for the system to restart, then enter 101 to check whether the IP address was
retained. If the system does not play back the IP address after dialing 101, this indicates that the VoIP
TA currently is not connected to the Internet. Please check and make sure the cable connections,
account numbers, and passwords are correct.
D-Link Systems, Inc.
VoIP Router Configuration-IVR
24
Advertisement
Table of Contents
