Symptom
Indoor or outdoor temperature display shows up
"LL".
Indoor or outdoor temperature display shows up
"HH".
Outdoor temperature display shows up "- - ".
Outdoor temperature display shows flashing
temperature.
This "- - " indicator is flashing on the outdoor
temperature display.
Transmitting indicator LED does not flash every 5
seconds after installing the battery.
TROUBLE SHOOTING GUIDE
Possibility causing/suggestion
If the indoor or outdoor temperature is below
o
o
–15
C / 5
F, "LL" shows. This is not an error.
If the indoor or outdoor temperature is over
o
o
55
C / 131
F, "HH" shows. This is not an error.
The code synchronization has been interrupted
and needs to be redone. Please follow "To
Synchronize Outdoor Temperature" steps 4 - 6.
The Thermo Sensor is to far away from the main
unit; move it closer to the main unit until the
temperature reading stops flashing.
NOTES:
Placing the main unit near any electrical
appliance, i.e. Computer, TV, monitor, etc, may
cause a signal interference. Please re-locate the
main unit.
Once the main unit has been relocated, it needs
to be resynced to the sensor. Please follow steps
4 – 6 in the "To Synchronize Outdoor
Temperature" section of the manual.
Main unit has started the code synchronization
with the Thermo Sensor, please move the
Thermo Sensor closer to main unit until the
outdoor
temperature
temperature.
Check to see if the batteries have been inserted
correctly. Please follow the battery polarity (pg.
12) to install battery.
If the battery is inserted correctly and the LED is
still not flashing, replace the battery.
16
display
shows
the