Changing A Fuse - CITROËN C4 Owner's Handbook Manual

CHANGING A FUSE

Access to the tools
The extraction tweezer is attached
to the back of the dashboard fusebox
cover.
For access to it:
 unclip the cover by pulling at the top
right, then left
 disengage the cover completely
and turn it over,
 remove the carrier, on the back of
which the tweezer is fi tted.
P R A C T I C A L I N F O R M A T I O N
Changing a fuse
Before changing a fuse:
 the cause of the failure must be
identifi ed and rectifi ed,
 all electrical consumers must be
switched off,
 the vehicle must be immobilised
with the ignition off,
 identify the failed fuse using the ta-
bles and diagrams in the following
pages.
To replace a fuse, you must:
 use the special tweezer to extract
the fuse from its housing and check
the condition of its fi lament.
 always replace the failed fuse with
a fuse of the same rating (same col-
our); the use of a fuse of different
rating fuse may cause malfunctions
(risk of fi re).
If the fault recurrs soon after replac-
ing the fuse, have the electrical system
checked by a CITROËN dealer or a
qualifi ed workshop.
The replacement of a fuse not
mentioned in the tables below
may cause a serious malfunc-
tion of your vehicle. Contact a
CITROËN dealer or a qualifi ed
workshop.
Good Failed
Tweezer
Installing electrical
accessories
Your vehicle's electrical
tem is designed to operate with
standard or optional equipment.
Before installing other
trical equipment or accesso-
ries on your vehicle, contact a
CITROËN dealer or a qualifi ed
workshop.
CITROËN will not accept re-
sponsibility for the cost incurred
in repairing your vehicle or for
rectifying malfunctions resulting
from the installation of accesso-
ries not supplied and not recom-
mended by CITROËN and not
installed in accordance with its
instructions, in particular when
the combined consumption of
all of the additional equipment
connected exceeds 10 milliam-
peres.
sys-
elec-
11
209