Download  Print this page

Control Codes; Cable Connection; Lan Connector - NEC X464UN Installation Manual

46” led lcd display
Hide thumbs
   

Advertisement

X464UN Installation Guide
46" LED LCD Display

Control Codes

NOTE: Contact your NEC rep for codes not listed.
NOTE: Use a cross/reverse/null modem cable.

Cable Connection

Communication Protocol:
Interface:
Communication:
Baud Rate:
Data Length:
Parity:
Stop Bit:
Communication Code:
PC Control Connector (D-Sub 9P)
NOTE:
If so desired, jumper "Request to send" and "Clear to Send" together on both ends of the cable to simplify cable connection. These
connections are not required. The only connections required are pins 2 (TxD), 3 (RxD) and 5 (GND)
www.necdisplay.com
RS-232C
Asynchronous
9600 bps
8 bits
None
1 bit
Hex
NEC Display Solutions of America, Inc.
Interface:
Communication Layer:
IP Address:
Port Number:

LAN Connector

Transmit Data+
Transmit Data-
Receive Data+
Not Used
Not Used
Receive Data-
Not Used
Not Used
X464UN
Rev 1.0
TCP/IP (Ethernet)
Transport Layer (TCP)
192.168.0.10 (Default)
7142 (Fixed)
Page 6 of 7

Advertisement

loading

  Also See for NEC X464UN

  Related Manuals for NEC X464UN